CORRIM Company FRP DOORS
In accordance with a continuing program of product research and development, CORRIM Company reserves the right to change design and/or details of its products without notice. All details, drawings, and dimensions are accurate for estimating purposes at the time of publication. Specific information for job details and drawings should be obtained from CORRIM Company offices or distributors.
CORRIM Company
Corrosion Immune Fiberglass Doors & Frames 1870 Stillman Drive • Oshkosh, WI 54901-1010 (920) 231-2000 FAX (920) 231-2238 Internet Address: E-mail Address: www.corrim.com
[email protected]
TECHNICAL FACT SHEET
20-14
CORRIM Company
DOOR EDGE DETAILS
TYPICAL CONSTRUCTION DETAIL Solid FRP Reinforcement At All Structural Joints
FRP Closer Reinforcement Beveled Edge 1/8” In 2” Standard
Solid Hinge Reinforcement Cores Available: Urethane, Balsa, Honeycomb
FRP Face Sheets Available: Smooth, Pebble, Woodgrain
Square Edge Optional
Solid FRP Lock Reinforcements Radiused Edge Optional Reinforcements For All Hardware Locations
Seamless FRP Door is Finished Following Machining For Hardware
Rabbeted Edge Optional
For Larger Panels, Additional Intermediates May Be Placed Both Horizontally & Vertically
Concealed And Surface Panic Hardware Preps Are Available Square Or Radiused
Mortise Strike
Hinge Preparation Per Template
Square Or Radiused
Cylindrical Lock
Mortise Lock Machined & Prepped Per Template Requirements
Lever Extension Flush Bolt Or Concealed Panic Rod Device
CORRIM Company
TYPICAL DOOR CONFIGURATIONS
Transom and Sidelite Door Systems
VP
GP
FGP
NXP
Sliding Panels With Vision Area RVP
FGLP
LP
GLP
OPTIONAL GLAZING DETAILS Glazing
Glazing Tape
Glazing
Polymer Moulding
FRP Stop
Glazing Tape
Glazing Tape
Glazing Glazing Glazing Tape Tape
Insulated Glazing Unit
Polymer Moulding S.S. Screw
S.S. Screw S.S. Screw Rabbett Vision Lite Single
Standard Vision Lite Single
Rabbett Vision Lite Single
Sanitary Flush Glazed Door 1-3/4” IGU
Bonded In Place With A Black Urethane Adhesive
OPTIONAL LOUVER DETAILS 1/2” Blade Gap STAINLESS STEEL SCREWS
Drain Ports (As Required)
Typical FRP Louver
CORRIM Company
HANDING DATA How to Determine Hand and Swing 1. The hand of a door is determined from the outside. 2. The outside of an entrance door is the street side
Outside Left Hand
Right Hand
3. The outside of a room door is the corridor side. 4. The outside of a communicating door is the side from which hinges are not visible with door closed. 5. The outside of a closet door is the room side.
Outside Left Hand Reverse
Right Hand Reverse
6. The key side (x) will be outside, unless otherwise specified. On Pairs of Doors Key Side Right hand leaf is always active unless specified.
Outside Double Swing In
Double Swing Out
