VCO SIMULATION WITH CADENCE SPECTRE

Download Vishal Saxena. -2-. Contents. ❑. VCO voltage tuning range. ❑. Frequency pushing. ❑. Phase noise. Note: the simulation results shown are not...

0 downloads 523 Views 315KB Size
Department of Electrical and Computer Engineering

VCO Simulation with Cadence Spectre Kehan Zhu, Vishal Saxena AMS Lab, Boise State University http://www.lumerink.com/

© Vishal Saxena

-1-

Contents   

VCO voltage tuning range Frequency pushing Phase noise

Note: the simulation results shown are not optimized, and provided only for simulation guidance purpose.

© Vishal Saxena

-2-

KVCO simulation PSS (Periodic Steady State) Analysis  Any Verilog-A models are not allowed in the simulation bench, PSS does not support Verilog-A.  Do .tran analysis first to estimate the VCO frequency at the fixed Vctrl as the Beat frequency.  Make sure the VCO works by setting the “Initial Condition”, “tstab” should be longer than the time the VCO needs to stable.  If the VCO frequency is off the beat frequency by too much over sweeping Vctrl, PSS may fail. So confine the Vctrl to a reasonable range.  After finishing simulation, go to ADE Results->Direct Plot>Main Form…open the Direct Plot Form, see later

© Vishal Saxena

-3-

PSS setup

© Vishal Saxena

-4-

PSS Plotting

Choose the fundamental frequency to plot Also, you can use calculator setting the outputs as above to get the KVCO plot, see next.

© Vishal Saxena

-5-

PSS simulation plots

VCO frequency and KVCO versus Vctrl are plotted.

© Vishal Saxena

-6-

Frequency Pushing To test the VCO frequency changing with power supply voltage variations, in the same manner as before, just change the sweeping variable to “vdd”. Notice here beat frequency is defined as a variable for easy change at the ADE.

© Vishal Saxena

-77

PSS simulation plots

© Vishal Saxena

-8-

Phase noise

Setup PSS first, then Pnoise

© Vishal Saxena Acharya © Vishal Saxena and Venkatesh

-99

Pnoise Simulation Result

© Vishal Saxena

-1010