XD: Light Bar - Access-Honda.com

INSTALLATION. CAUTION. • To prevent burns, allow the engine, exhaust system, radiator, etc. to cool before installing the accessory. NOTE: • This manu...

34 downloads 708 Views 365KB Size
Accessory

Application

Publication No.

MII 15736

INSTALLATION INSTRUCTIONS

LIGHT BAR

P/N 08P71-MKA-D80

After ‘15 NC700X/XD

Issue Date

March 2016

Honda Dealer: Please give a copy of these instructions to your customer. PARTS LIST

Please Convey the Following Information to the Customer During Delivery NOTICE: • DO NOT GRASP THE LIGHT BAR OR ATTACHED ACCESSORIES TO MOVE THE MOTORCYCLE AS IT MAY DAMAGE THE MOTORCYCLE AND ACCESSORIES.

(2)

(1)

INSTALLATION (3)

CAUTION • To prevent burns, allow the engine, exhaust system, radiator, etc. to cool before installing the accessory. NOTE: • This manual is focusing on NC700XD, but other models are similar. If there are any differences, each difference will be described in this manual. • Take care not to damage the painted surfaces of the motorcycle.

(4) (7) (6) (8) (5)

No. (1)

Description

Qty

Right light bar

1

(2)

Left light bar

1

(3)

Light bar holder

2

(4)

6 mm flange bolt (short)

3

(5)

6 mm flange bolt (long)

2

(6)

6 mm flange nut

3

(7)

Wire tie

1

(8)

Installation Instruction URL

1

TOOLS REQUIRED Socket (10 mm) Ratchet Box-end wrench (10 mm) Torque wrench

TORQUE INFORMATION Refer to the Service Manual for the torque values of the removed parts. Unless otherwise indicated, follow the specified torque in the chart. Item 6 mm flange bolt and nut

N·m

kgf·m

lbf·ft

12

1.2

9

© 2016 American Honda Motor Co., Inc. - All Rights Reserved.

1 of 3

08P71-MKA-D80

1.

Loosely install the right light bar as shown.

2.

RIGHT LIGHT BAR

Loosely install the left light bar as shown. LEFT LIGHT BAR

LIGHT BAR HOLDER 6 mm FLANGE BOLT (short)

LIGHT BAR HOLDER 6 mm FLANGE BOLT (short) 6 mm FLANGE NUT

6 mm FLANGE NUT

6 mm FLANGE BOLT ((long) g)

6 mm FLANGE BOLT (long)

3.

Install the 6 mm flange bolt (short) and 6 mm flange nut as shown.

6 mm FLANGE BOLT (short) 6 mm FLANGE NUT

4. 2 of 3

Tighten all loosely installed hardware.

5.

Secure the motorcycle’s horn wire with the wire tie as shown.

HOLDER

WIRE TIE MOTORCYCLE’S HORN WIRE

3 of 3